Membrane degassing units

Membrane Degasser 

Membrane Degassing Units (MDU) are an efficient, compact and maintenance-free technology for removing carbon dioxide and oxygen from water without any chemical treatment. Membrane degassing is a standard technology used in a variety of industries such as boiler feedwater, power generation and pharmaceuticals.

Removing carbon dioxide and oxygen can prevent boiler and pipeline corrosion, protect capital investments, extend equipment life and reduce operating costs. Removing these gases can also improve process efficiency, such as for EDI performance.

Advantages of membrane degassing installation

 

Solution without chemistry

check-circle-1

Compact design

check-circle-1

Low installation cost

check-circle-1

Modular design with high adaptability

check-circle-1

How to Remove Gases from Water

A membrane degassing unit uses a microporous hollow fiber membrane to remove gases from water. The hollow fiber is knitted into a mass and wrapped around a central tube inside the housing.

During operation, water flows over the outside of the hollow fibers while a vacuum, ribbon gas, or both act on the inside of the fibers. Because the membrane is hydrophobic, it allows direct contact between the gas and water without dispersion.

Applying a higher pressure to the water stream than the gas stream creates a driving force that allows the dissolved gas in the water to pass through the pores of the membrane. The gas is then carried away by a vacuum pump and/or a purge gas.

Illustration on how to remove gases from water

Membrane degassing units


CO2 Removal

CO2 removal after RO and before EDI (or mixed ion exchange) reduces chemical usage and increases EDI throughput. Lower CO2 loading also improves silica removal. The goal is to reduce CO2 before EDI to less than 5 ppm. Blow-off mode.

Membrane degassing add on kit for RO

Additional kit

Available as standard additional kits, prepared for reverse osmosis units from ECOMAX . Technical specifications are available on request.

 

Membrane degassing unit on RO

Customized solution

Also available separately for on-site installation into existing reverse osmosis systems.

Membrane degassing unit on a frame-mounted water treatment solution

On a frame

The membrane degassing unit can also be part of a complete solution with several technologies - mounted on a frame and ready for use.

Removal of O2

To prevent corrosion and use chemicals.
Operating mode - vacuum pump with nitrogen as purge gas.

Membrane degassing unit from Eurowater

District Heating

By removing oxygen from district heating water, you prevent corrosion of your installations and distribution network.

 

Membrane degassing unit in stainless steel

Boiler Feedwater

Membrane degassing unit for oxygen removal to less than 20ppb according to EN12952-12. AISI 316 stainless steel frame mounted solution.

Memebrane degassing unit in stainless steel used in pharma

Distilled Water

Purpose - removal of oxygen in the cold water circuit. The MDU is designed for hot sanitization Clean-In-Place (CIP), which is a requirement for high purity water (HPW) of the United States Pharmacopoeia (USP) and the European Pharmacopoeia (Ph. Eur.). 

Recommendations

Water treatment and corrosion protection

The Danish District Heating Association has published its recommendations for proper water treatment to extend the life cycles of key assets such as boilers, valves, fittings, installations and underground piping.

Recommendations from Danish District Heating Association on water treatment and corrosion prevention

Get the optimal solution

The choice of installation depends on the area of application, quality and consumption of water. We are at your service to find the optimal solution based on our know-how. Fill out the form and we will contact you.


 

Feedback